In this manual, we describe the configuration of D4i Dongle for the typical case in which it is controlled by a Smart Bridge (coupled to, for example, a climate computer).
Prerequisites:
- Basic knowledge of the BeverApp
- Smart bridge configured to send an output Level to the D4i Dongle, see manual ...
- Map of the Smart networks and groups informed by the Smart Bridge
Please follow the following steps to configure your D4i Dongle:
- Authorize with the Dongle
- Add the Dongle to the Network and Group based on position of the Dongle on the map
Now, the Dongle will automatically listen to all levels send by the Smart Bridge to this network and group.
Please refer to the Settings manual in case more detailed configuration of your Dongle is required.
Follow these guides to add the dongle to your network:
Step 1: Creating a Bever account |
Once the devices are added to your preferred network, it's time to access your device settings. Click on the device you wish to configure.
Before you start configuring settings, ensure you have preemptively clicked on "Get Data".
In the Basic en Advanced menu, you'll find various options to customize the behavior of your dongle:
Basic
Name | Values | Description | Default |
Dali Bridge Mode | ON/OFF | DALI to EOS (off) / EOS to DALI (on) | OFF |
Repeat DALI command | [0-20] | Amount of informs | 0 |
Use Logarithmic output level | ON/OFF | Output Level | OFF |
Output power | [0-100]% | Maximum output level | 100% |
EOS to Dali: External motion interpretation
Time to dim | HOURS/MIN/SEC | Time it takes to dim | 2 MInutes |
Dim saving | [0-100]% | Percentage that should dim of the output | 70% |
Use deepdim | ON/OFF | uniform dimming | OFF |
Time to deepdim | HOURS/MIN/SEC | Time to deepdim (dim lvl 2) | 5 Minutes |
Deep-dim saving | [0-100]% | Percentage that should deep-dim of the output | 100% |
Dali to EOS
Startup percentage | [0-100]% | Percentage of startup output | 0% |
Use logarithmic output level | ON/OFF | Output Level | On |
Networks to inform | Networks available | Which available networks should informed | Own network |
Send new percentage | [0-300] | At which intervals a new percentage is set | 10 ms |
Numbers of hops | [0-20] | Number of hops between devices | 3x |
Advanced
Name | Values | Description | Default |
EOS | |||
Device network identifier | [1-30] | Network ID of Bridge | 1 |
Use external antenna | ON/OFF | The use of an external antenna | OFF |
EOS to Dali | |||
Output offset | [0-100]% | 0% | |
Attended timeout | HOURS/MINUTES | 0 | |
Motion priority | [0-20] | 7x | |
Use max with equal priority | ON/OFF | OFF | |
Same level priority | [0-20] | 100 | |
Always use latest level (ignore priority) | ON/OFF | OFF | |
Ignores EOS to DALI group mapping, just broadcast | ON/OFF | OFF |