• Read the manual carefully before installing the system.

  • Always adopt a safe posture. Use for this the applying rules.

  • All dimensions in this document are indicated in millimeters.

  • The display system is a complex electronic system.
    Only a Bever Innovations accredited service engineer is allowed to perform maintenance on the system.
  • The pole sign and the display system must be connected to a main protective earthing terminal.

  • Always switch off mains prior to installation or maintenance. This means the system must be physically separated from the mains. Secure the switch with a lock or other suitable means.

  • Make sure the correct wiring is used for the connection of the display system. Most commonly this will be 1,5 mm2 in combination with a 10A fuse. Make sure the correct fuse is always used for the applied wiring.

  • Never connect a PC directly to the configuration port of a Sign Controller 02 (SC02) or an Interface Controller (IC01 / IC-U). Always use the HC02 interface for connecting the PC to a configuration port.

  • Make sure that any circuitry connected to the sign controller (the light switch port in particular), meet the requirements of the IEC 60950-1 international standard.

  • Never connect cable ties to the housing of the power supply. Instead use the cable tie rail which is located at the bottom of the sign controller housing.

  • All Printed Circuit Boards (PCB) supplied by Bever Innovations B.V. must be handled as ESD sensitive devices. For more information on this subject please check ESD precautions for all Bever Innovations Printed Circuit boards

  • The display system is protected against water in an upright position. Whenever transported in a pole sign, make sure the sign is properly sealed to prevent water from leaking into the display system.

  • Do not power up the system immediately after transport from a cold to a warm place or vice versa, or under conditions of extreme humidity. Wait until all humidity is gone from the system components, before powering up the system.

  • Take care of the environment while working with products of Bever Innovations, by separation of waste.

  • Bever Innovations cannot be held responsible in any way for injury to people or damage to the system.
  • Make sure the ventilation in- and outlets on the back and bottom of the displays are clear to prevent overheating.