Some settings for the mobile connection of the Internet Bridge can only be changed through a special web interface on the Bridge. To do so:


  1. Download and install the driver for the bridge; (download)
  2. Connect a mini USB cable between the 'service'-port on the Bridge and your laptop;
  3. Power on the bridge and wait about 1 minute;
  4. Open your browser and go to http://192.168.2.2/mobile
  5. Here you can change some settings related to the sim card. For most commercially available sim cards from major providers, 'Automatic' APN selection will work. 
  6. If you are using more special sim cards, for example from IoT providers, you likely need to enter an APN and sometimes also a username and password. Your sim card provider should provide you with this information.
  7. Set the APN Selection to 'Manual (enter below)' and then enter the information provided. If you also need to enter a username and password, please select the right authentication method (PAP or CHAP).
  8. Click 'Save' and restart the bridge.
  9. After restarting, you can check this page again. The lower half of the page shows some information regarding receive strength, roaming, access to the network and so on.


Note: this feature is available for Internet Bridges with software version 0.99 and up.